Clearing The Error Log; Understanding Error Codes; Non-Fatal Error Codes; Fatal Error Codes - Precor Energy Series Service Manual

Clearing the Error Log

Access the Information Display (65), scroll to the Error Log menu and press the GO control to
select. Any logged error codes will be shown.
Press and hold the GO control for around 5 sec's until the "ERROR LOG CLEAR" message
will be shown to indicate that the error log has been cleared of all current error codes.

Understanding Error Codes

There are two categories of Error Codes: Fatal and Non-Fatal errors.
Fatal error code messages will continue to show until the
power is cycled (OFF/ON). The console is locked except
access to the Display Error Log
messages will continue to return until the error issue is
resolved.
The following error codes are provided for quick
reference only and may not contain the most current
information. Refer to the Error Code Troubleshooting
Guide pdf for detailed error code description and
troubleshooting information. Use the following hyperlink
download the most current version:
Precor website hyperlink:
Guide

Non-Fatal Error Codes

Code Error description
05 Stuck Key
10 AC Frequency
40 Lift error: lift won't move
42 Lift error: bad pot reading
44 Lift error: non commanded lift
motion
45 Lift error: lift going in the
wrong direction

Fatal Error Codes

Code
00 Upstairs EEPROM checksum error
© 2014 Precor Incorporated, Unauthorized Reproduction and Distribution Prohibited by Law
page. Error code
Error Code Troubleshooting
Non-Fatal Error Codes
Expected behavior following error detection
Do not allow further operation and display error until the Stuck
Key event is cleared. Does not require power cycle to clear.
For lift errors, do not interrupt operation of the treadmill and do
not stop belt. Display error code for two seconds, then log. If
incline keys are pressed, do not operate incline but display the
error code again for two seconds. Allow full operation of lift
motor again after the power is cycled.
Fatal Error Codes
Error description
input
for
to
Page 35 of 56