Getting Service - Precor M9.3s Owner's Manual

Photo 9
page 28
Aligning the
running belt.
Right-hand
adjusting screw
6. After adjusting the belt, let the treadmill run for a couple of minutes to check
the alignment and to make sure the belt is stable. If more correction is
required, repeat steps 4 and 5 by turning the adjusting screw another 1/4
turn, then check the result. If you overcorrect, turn the screw in the opposite
direction. (Refer to Photo 9.)
7. Once the belt is properly aligned, press the STOP key to stop the belt.

Getting Service

Do not attempt to service the M9.3s Low-Impact treadmill yourself except for
performing the maintenance tasks as described in this manual.
For further information about product operation or service, contact an
authorized Precor dealer (or a Precor Factory Authorized Service Company).
To locate the Precor dealer nearest you, call 1-800-4-PRECOR.