●
Select <On> in <Auto Acquire>, and select <Select Protocol>
Black and white LCD model
●
Select <Select Protocol>
If you do not want to use DHCP/BOOTP/RARP to assign an IP address
●
Select <Off>. If you select <DHCP> when these services are unavailable, the machine will waste time
and communications resources searching the network for these services.
3
Check that <Auto IP> is set to <On>.
●
If <Off> is selected, change the setting to <On>.
4
Select <Apply>.
●
IP addresses assigned via DHCP override the address obtained via Auto IP.
Manually entering an IP address
1
Configure a setting to disable auto-acquisition.
Touch panel model
●
Select <Auto Acquire>, and select <Off> in <Auto Acquire>
Black and white LCD model
●
Select <Auto Acquire>, and set both <Select Protocol> and <Auto IP> to <Off>.
2
Select <Manually Acquire>.
3
Specify the IP address, subnet mask, and gateway address (or default gateway).
Touch panel model
●
Enter <IP Address>, <Subnet Mask>, and <Gateway Address>, and select <Apply>.
Black and white LCD model
●
Enter these values in each screen using the numeric keys, and press
5
Restart the machine.
●
Turn OFF the machine, wait for at least 10 seconds, and turn it back ON.
Checking whether the settings are correct
●
Make sure that the Remote UI screen can be displayed with your computer (
If a computer is not available, you can check the connection by using the operation panel (
Network Connection(P. 43) ).
When you have changed the IP address after installing the printer driver
●
You need to add a new port.
Setting Up
<DHCP>.
Configuring Printer Ports(P. 54)
42
<DHCP>.
<Apply>.
.
Starting Remote UI(P. 275) ).
Testing the