Passive Arming; Pag; Door Switch Polarity Selection; Hazard Warning Lights Or Negative Output During An Alarm - Gemini 932IT Installation And User Manual

Hide thumbs Also See for 932IT:

Table of Contents

This function arms the system 60 sec. after ignition is switched OFF and the last door is opened and

closed. If a door is opened during this lapse of time, the procedure is interrupted; it resumes when the

door is closed.

This function modifies the alarm input signal (positive or negative) based on the signal generated

the door switch.

8.5

HAZARD WARNING LIGHTS or NEGATIVE OUTPUT DURING ALARM

This function activates the optical signals based on the connections made.

NB:

Only for vehicles where hook-up is to the Hazard warning lights.

Optical signals activated by connection to the Hazard switch ONLY turn ON during an

In this case, do not connect the alarm ORANGE wires to the turn indicator wires.

If this function is disabled, the BLUE wire will carry a negative signal during an alarm cycle.

Here below is an example that illustrates the various steps to modify the programmable functions

As mentioned before, every key cycle disables the functions, while the touch key enables them.

Two different tones will sound depending on the action taken and the LED will flash according to the

selected function (see par. .0).

With the system disarmed, turn ignition key "ON" and touch the key to its receptacle.

Two acoustic signals (a Beep and a Bop) and two flashes of the turn indicators will acknowledge that

the system has entered in programming mode.

8.3 -

8.4

The alarm BLUE wire MUST be connected to the Hazard switch.

0 -

PASSIVE ARMING

alarm condition.

INSTALLER MANUAL - PAGE 13

Table of Contents

Show Quick Links

Table of Contents