Ultrasonic Volumetric Protection; Connections And Positioning; Pag; Sensor Adjustment - Gemini 932IT Installation And User Manual

• Insert the WHITE connector in the "W" socket.
• Insert the RED connector in the "R" socket.
• Install the ultrasonic sensors on the top part of the windshield internal pillars, away from the air vents
and point them towards the center of the rear window
To check the sensitivity level proceed as follows:
• With the alarm system disarmed,
• Set the trimmer to an intermediate position (medium sensitivity)
• Close all doors, bonnet and boot and arm the system
• During the arming delay
the status LED will turn OFF to signal a presence.
• If the sensitivity level
SENSITIVITY
ADJUSTMENT
!
It
To reset the system proceed as follows:
• Disconnect the alarm power supply.
• Short-circuit the RED and BLACK wires of the 2-pin LED connector.
• Power the system; 4 acoustic signals and 4 flashes of the turn indicators will confirm the operation.
• Remove the previously created short-circuit; the status LED will light up steady.
• Turn ignition key "ON"; reset is confirmed by an acoustic signal and the wailing of the siren for
approx. 3 sec.
• Turn ignition key "OFF"; the status LED will turn OFF. There are no acoustic signals.
PAGE 16 - INSTALLER MANUAL
12. 0 -

ULTRASONIC VOLUMETRIC PROTECTION

12.1 -

CONNECTIONS AND POSITIONING

12.2
roll down the front window approx. 20 cm
introduce an object in the cabin through the window and move it around;
is too high or too low, readjust the trimmer and repeat the above procedure

13.0 - SYSTEM RESET

This procedure will restore factory settings.
must therefore only be used in case of need, before programming the
system or learning the turn indicators flashes
.

- SENSOR ADJUSTMENT

.
.
.
CELL
CONNECTIONS
.
.