Figure 31: Fan Status Led - Front And Rear Sides; Table 13: System Status Led Assignments; Table 14: Fan Status Led Assignments - Mellanox Technologies SX1012 User Manual

Table 13 - System Status LED Assignments
LED Behavior
Solid Green
Flashing Green
Solid Red
Off
3.3.1.2 Fan Status LED
Table 14 - Fan Status LED Assignments
LED
Behavior
Solid
Green
Solid Red
Rev 1.4
Description
The system is up and running (normal
condition).
The system is booting up. This assign-
ment is valid on managed systems only.
Major Error has occurred. For example,
corrupted firmware, system is over-
heated etc.
The system has no power.
All fans must be operating while the power supply is plugged in.

Figure 31: Fan Status LED - Front and Rear sides

Mellanox
®
PS1
PS2
UID
RST
Description
All fans are up and running (nor-
mal condition).
Error, one or more fans is not
operating properly.
Mellanox Technologies
N/A
Wait up to five minutes for the end of the
booting process.
If the System Status LED shows red five
minutes after starting the system, unplug
the system and call your Mellanox repre-
sentative for assistance.
Check the power source and cable.
This is a two color LED
!
Action Required
N/A
In case there is an FRU, the module should be replaced.
Otherwise, the system should be replaced.
Interfaces
Action Required
53