Output Functions; Bcd Output Functions - AND AD-4401A Instruction Manual

13.3. Output Functions

Select a data output timing (bCdF-02) from the following:
- Interval output at the display update rate (FncF-03)
- In synchronization with automatic print
- In synchronization with manual print
Timing chart
Data output
Strobe output
Hold input
The valid data output width is twice the strobe output width. Read the data within the valid data output width.
The strobe output width depends on the display update rate (FncF-03).
Display update rate
20 times/s
10 times/s
5 times/s
Update will stop within 50 ms after the hold input turns ON. Then, update will restart within 50 ms after the
hold input turns OFF.

13.4. BCD Output Functions

For the function setting procedure, refer to "19. GENERAL FUNCTION SETTING."
bCdF-
01 Output weight value
02 Data output timing
03 Data output logic
04 Strobe output logic
AD-4401A
Valid data output width
Strobe output width
50 ms
Strobe output width
20 ms
45 ms
95 ms
Item
Page 44
50 ms
Setting Value
1: Displayed weight value
2: Gross value
3: Net value
4: Tare value
1: Interval output at the display update rate
(FncF-03)
2: In synchronization with automatic print
3: In synchronization with manual print
1: Positive logic (Open-circuit is ON)
2: Negative logic (Short-circuit is ON)
1: Positive logic (Open-circuit is ON)
2: Negative logic (Short-circuit is ON)
Default
1
1
2
2