Transferring Another Terastation's Settings; Creating A Config File (.Nas_Config) - Buffalo TeraStation 5010 User Manual

4
From "Target USB Drive", select the USB drive that is connected to the USB port on the TeraStation.
5
Select "Transfer settings from a USB drive", then click Execute.
6
The "Confirm Operation" screen will open. Enter the confirmation number, then click OK. The TeraStation will
apply the settings.
7
When the "finished" message is displayed, applying settings is finished. Click OK.

Transferring Another TeraStation's Settings

You can transfer saved settings from another series TeraStation to your TeraStation. The following settings can be
transferred:
• Shared folders which are created from "File Sharing"- "Folder Setup"
• Access restrictions
• Users
• Groups
Note: This feature currently supports the following series of TeraStations as of August 2016. The latest
compatibility information will be on the Buffalo website.
• TS-X series firmware version 1.58 or later
• TS3000 series
• TS4000 series
• TS5000 series
• TS3010 series
• TS5010 series

Creating a Config File (.nas_config)

Procedure for TS-X Series
To transfer settings from TS-X series TeraStations, it will use the "NS-SHFT" software to create a config file. The NS-
SHFT can be downloaded from the Buffalo website.
For the procedure on creating the config file, refer to the NS-SHFT user guide.
Procedure for TeraStations Other Than TS-X Series
Follow the procedure below to create a config file on a TeraStation that is not a TS-X series.
1
Refer to the user manual of the TeraStation that you want to transfer settings for saving settings to a USB drive.
120