System Configuration Via Bootp - Hirschmann MACH 4000 User Manual

Entering the IP Parameters
2.5 System configuration via
BOOTP
When it is started up via BOOTP (bootstrap protocol), a Switch receives its
configuration in accordance with the "BOOTP process" flow chart
13).
Note: In its delivery state, the Switch gets its configuration data from the
DHCP server.
Activate BOOTP to receive the configuration data
tem configuration via the Web-based interface")
enable
configure protocol bootp
copy system:running-config
nvram:startup-config
y
Provide the BOOTP server with the following data for a Switch:
# /etc/bootptab for BOOTP-daemon bootpd
#
# gw -- gateway
# ha -- hardware address
# ht -- hardware type
# ip -- IP address
# sm -- subnet mask
# tc -- template
.global:\
:gw=0.0.0.0:\
:sm=255.255.240.0:
16

2.5 System configuration via BOOTP

(see on page 25 "Sys-
or see in the CLI:
Switch to the Priviledged EXEC mode.
Activate BOOTP.
Activate BOOTP.
Confirm save..
(see fig.
Basic - L3P
Release 4.0 11/07