Table of Contents
Advertisement
If the Sound has been muted, the Console will display the "AUDIO OFF" prompt for a few seconds.
Note: Your treadmill comes equipped with a durable, high quality walking belt designed to provide many hours of reliable service. The walking
belt on a treadmill that has not been operated for a length of time, either in factory packaging or after assembly, can exhibit a "thump-
ing" noise when started. This is due to the belt taking on the curve of the front and rear rollers. This is a common occurrence and does
not indicate a problem with your machine. After the treadmill has been used for a short period of time the thumping noise will discon-
tinue. The amount of time will vary depending on the temperature and humidity of the environment where the treadmill is placed.
Power Up / Idle Mode
The Console will enter Power Up mode when initially plugged into a power source and the On/Off button is switched to On.
The belts will only move after a 3 second, audible beep countdown.
Shut Off (Sleep Mode)
If the Console does not receive any input for five minutes, it will automatically shut off unless in Demonstration mode.
Push any button to start (wake up) the Console. If your machine is in Demonstration mode, push and hold down for 3 seconds the ENTER and
PAUSE/STOP buttons.
To prevent unsupervised operation of the machine always turn the power switch to Off, remove the Safety Key, and disconnect the
power cord from the wall outlet and machine power input. Place the power cord in a secure location.
Initial Setup / Adjust Date and Time
During the first power-up, the Console will request the date and time for workout tracking. To adjust these settings after the Initial Setup, push and hold
the USER and PAUSE/STOP buttons from the Power-Up Mode screen.
1. The Console display shows the SET DATE prompt with the default date setting. The month value will be the currently active values (flashing).
Push the Increase () or Decrease () buttons to adjust the currently active value (flashing). Push the Left () or Right () buttons to change
which segment is the currently active value (month / day / year ).
2. Push the Right button until the next prompt is displayed.
3. The Console display shows the SET TIME prompt with the default time setting. The hour value will be the currently active values (flashing). Push
the Increase/Decrease buttons to adjust the currently active value (flashing). Push the Left/Right buttons to change which segment is the currently
active value (hour / minute / AM or PM).
4. Push Enter to set.
The Console goes to the Power-Up Mode screen.
User Profiles
The Console is equipped with 4 User Profiles. Each User Profile has values and options specific to it:
• Gender
• Year of Birth
• Display Units
• Weight
• Screen Brightness
• Erase Workouts
41
Assembly / Owner's Manual
Hide quick links:
Advertisement
Table of Contents
