Installing Ip Phones At A Remote Site With A Built-In Media Relay Gateway - Panasonic KX-NS700 Installation Manual

5.8.4 Installing IP Phones at a Remote Site with a Built-in Media Relay Gateway

5.8.4 Installing IP Phones at a Remote Site with a Built-in Media
Relay Gateway
The PBX contains a built-in Media Relay Gateway. You can install and register IP-PTs (KX-NT500 series),
Panasonic IP-Softphones, IP-CSs (KX-NS0154 only), KX-UT series SIP phones and third party SIP phones
at a remote site without adding an SBC (Session Border Controller). Also, you do not need to configure special
network settings (NAT traversal, etc.) at the remote site.
Switching Hub
PC
IP-PT
Main Site
: LAN
: WAN
Note
•
This feature does not require an activation key.
•
There is no limit to the number of terminals that can use the Media Relay Gateway feature.
However, there are some conditions, as follows:
–
Peer-to-peer communication is not supported for the built-in Media Relay Gateway.
–
The number of terminals using TR-069 (CWMP)-based HTTPS is limited.
•
For information about which telephone models support the built-in Media Relay Gateway, consult your
dealer.
Programming the PBX with Built-in Media Relay Gateway
Follow the procedures below to configure remote port settings using Web Maintenance Console.
Note
For the procedures below, program WAN side IP information of the router at the main site. This information
is sent to KX-NT500 series, IP-CSs (KX-NS0154 only), or KX-UT series SIP phones in the remote site after
completing all programming.
For Site Property Settings
1. Click Setup ® PBX Configuration ® Configuration ® Slot.
2.
Move the mouse pointer over System Property.
A menu will be shown under the mouse pointer.
3.
Click Site.
4.
Click the Media Relay tab.
236 Installation Manual
PBX
Router
Built in Media
Relay Gateway
Internet
Switching Hub
Router
IP-PT
Remote Site
KX-UT
series
SIP phone
Document Version 2016-03