Starting The Pbx - Panasonic KX-NS700 Installation Manual

4.13 Starting the PBX

WARNING
Make sure that the AC outlet is properly grounded, then securely connect the 3-pin AC plug
including the grounded pin.
CAUTION
•
Use only the AC power cord included with the PBX.
•
Before touching the product (PBX, cards, etc.), discharge static electricity by touching ground or
wearing a grounding strap. Failure to do so may cause the PBX to malfunction due to static electricity.
•
Once you have started the PBX, if you unplug the PBX, do not initialize it again as described in "System
Initialization Procedure". Otherwise, your programmed data will be cleared. To restart the PBX, refer
to "7.1.5 Restarting the PBX".
•
The plug of power supply cordset is used as the main disconnect device. Ensure that the AC outlet is
located near the equipment and is easily accessible.
Installing the Hook Clip for the AC Power Cord
1.
Insert the hook clip into the hook clip hole.
Note
Use only the hook clip included with the PBX.
Document Version 2016-03
4.13 Starting the PBX
Installation Manual 149