Starting The Pbx - Panasonic KX-HTS824 Getting Started

3.8 Starting the PBX

WARNING
Make sure that the AC outlet is properly grounded, then securely connect the 3-pin AC plug including
the grounded pin.
CAUTION
•
Use only the AC power cord included with the PBX.
•
Before touching the product (PBX, cards, etc.), discharge static electricity by touching ground or
wearing an grounding strap. Failure to do so may cause the PBX to malfunction due to static
electricity.
•
Once you have started the PBX, if you unplug the PBX, do not initialize it again as described in
"System Initialization Procedure". Otherwise, your programmed data will be cleared. To restart the
PBX, refer to "6.1.4 Restarting the PBX".
•
The plug of power supply cordset is used as the main disconnect device. Ensure that the AC outlet is
located near the equipment and is easily accessible.
Connecting the AC Power Cord
Note
For safety reasons, do not stretch or pinch the AC power cord.
System Initialization Procedure
The system can be reset to its original default state by pressing the Initialize switch while turning the system
power on.
The system initialization startup operation is as follows.
•
Turn on the system power and press and hold the Initialize switch.
For more information, refer to 5.3 System Initialization Procedure.
•
When system initialization is complete, operation begins (green LED illuminated).
Performing a system initialization returns the system data to its default settings.
The memory state is also cleared.
3.8 Starting the PBX
Getting Started 85