Table of Contents
Advertisement
1.3 ENERVISTA UR SETUP SOFTWARE
10. Click the Read Order Code button to connect to the B90 device and upload the order code. If a communications error
1
occurs, ensure that the EnerVista UR Setup serial communications values entered in the previous step correspond to
the relay setting values.
11. Click the OK button when the relay order code has been received. The new device is added to the Site List window (or
Online window) located in the top left corner of the main EnerVista UR Setup window.
The device has now been configured for RS232 communications. Proceed to the Connecting to the B90 section to begin
communication.
c) CONFIGURING ETHERNET COMMUNICATIONS
Before starting, verify that the Ethernet network cable is properly connected to the Ethernet port on the back of the relay. To
setup the relay for Ethernet communications, you define a Site, then add the relay as a Device at that site.The computer
and UR device must be on the same subnet.
1.
Verify that the latest version of the EnerVista UR Setup software is installed (available from the GE EnerVista CD or
online from http://www.gedigitalenergy.com/multilin). See the Software Installation section for installation details.
2.
Select the "UR" device from the EnerVista Launchpad to start EnerVista UR Setup.
3.
Click the Device Setup button to open the Device Setup window, then click the Add Site button to define a new site.
4.
Enter the desired site name in the "Site Name" field. If desired, a short description of site can also be entered along
with the display order of devices defined for the site. In this example, we use "Location 2" as the site name. Click the
OK button when complete.
5.
The new site appears in the upper-left list in the EnerVista UR Setup window. Click the Device Setup button then
select the new site to re-open the Device Setup window.
6.
Click the Add Device button to define the new device.
7.
Enter the desired name in the "Device Name" field and a description (optional) of the site.
8.
Select "Ethernet" from the Interface drop-down list. This displays a number of interface parameters that must be
entered for proper Ethernet functionality.
9.
Enter the relay IP address specified in the
in the "IP Address" field.
ADDRESS
1-8
Figure 1–5: CONFIGURING ETHERNET COMMUNICATIONS
SETTINGS
B90 Low Impedance Bus Differential System
PRODUCT SETUP
COMMUNICATIONS
1 GETTING STARTED
NETWORK
IP
GE Multilin
Advertisement
Table of Contents
