Table of Contents
Advertisement
4.3 FACEPLATE INTERFACE
1.
Bend the tabs at the left end of the tool upwards as shown below.
2.
Bend the tab at the center of the tool tail as shown below.
4
The following procedure describes how to remove the LED labels from the B90 enhanced front panel and insert the custom
labels.
1.
Use the knife to lift the LED label and slide the label tool underneath. Make sure the bent tabs are pointing away from
the relay.
4-18
B90 Low Impedance Bus Differential System
4 HUMAN INTERFACES
GE Multilin
Advertisement
Table of Contents
