GE B90 UR Series Instruction Manual page 134

Low impedance bus differential system
Hide thumbs Also See for B90 UR Series:
Table of Contents

Advertisement

5.2 PRODUCT SETUP
d) NETWORK
As outlined in the previous section, when using more than one Ethernet port, configure each to belong to a different net-
work or subnet using the IP addresses and mask.
PATH: SETTINGS
PRODUCT SETUP
 NETWORK PORT 1
 NETWORK PORT 2
5
 NETWORK PORT 3
These messages appear with the Ethernet card present.
The
PRT1 (2, 3) GOOSE ENABLED
determines if ports 2 and 3 operate in redundant or independent mode. In non-redundant mode, port 2
PRT2 REDUNDANCY
and 3 operate independently with their own MAC and IP address. In redundant mode, port 2 and 3 use the port 2 MAC and
IP address, port 3 is in standby mode and monitors its link to the Multilink switch, and when port 2 detects a problem with
the link then communication switches to port 3 until the link returns.
The IP addresses are used with the DNP, Modbus/TCP, IEC 61580, IEC 60870-5-104, TFTP, and HTTP protocols. The
NSAP address is used with the IEC 61850 protocol over the OSI (CLNP/TP4) stack only. Each network protocol has a set-
ting for the TCP/UDP port number. These settings are used only in advanced network configurations and should normally
be left at their default values, but may be changed if required (for example, to allow access to multiple UR-series relays
behind a router). By setting a different
map the relays to the same external IP address. The client software (EnerVista UR Setup, for example) must be configured
to use the correct port number if these settings are used.
5-20

COMMUNICATIONS
PRT1 IP ADDRESS:
0.0.0.0
PRT1 SUBNET IP MASK:
MESSAGE
0.0.0.0
PRT1 GWY IP ADDRESS:
MESSAGE
0.0.0.0
PRT1 GOOSE ENABLED:
MESSAGE
Enabled
PRT2 IP ADDRESS:
0.0.0.0
PRT2 SUBNET IP MASK:
MESSAGE
0.0.0.0
PRT2 GWY IP ADDRESS:
MESSAGE
0.0.0.0
PRT2 REDUNDANCY:
MESSAGE
No
PRT2 GOOSE ENABLED:
MESSAGE
Enabled
PRT3 IP ADDRESS:
0.0.0.0
PRT3 SUBNET IP MASK:
MESSAGE
0.0.0.0
PRT3 GWY IP ADDRESS:
MESSAGE
0.0.0.0
PRT3 GOOSE ENABLED:
MESSAGE
Enabled
setting provides the ability to disable/enable GOOSE transmission from the port.
TCP/UDP PORT NUMBER
B90 Low Impedance Bus Differential System

NETWORK 1(3)
Range: Standard IPV4 address format
Range: Standard IPV4 address format
Range: Standard IPV4 address format
Range: Enabled, Disabled
Range: Standard IPV4 address format
Range: Standard IPV4 address format
Range: Standard IPV4 address format
Range: No, Yes
Range: Enabled, Disabled
Range: Standard IPV4 address format
Range: Standard IPV4 address format
Range: Standard IPV4 address format
Range: Enabled, Disabled
for a given protocol on each UR-series relay, the router can
5 SETTINGS
GE Multilin

Advertisement

Table of Contents
loading

Table of Contents