GE B90 UR Series Instruction Manual page 149

5 SETTINGS
The minimum value for all quantities is 0; the maximum values are as follows:
phase current: 46  phase CT primary setting
•
neutral current: 46  ground CT primary setting
•
voltage: 275  VT ratio setting
•
power (real, reactive, and apparent): 46  phase CT primary setting  275  VT ratio setting
•
• frequency: 90 Hz
• power factor: 2
The GGIO1 status configuration points are shown below:

PATH: SETTINGS PRODUCT SETUP
 GGIO1 STATUS
 CONFIGURATION
MESSAGE
MESSAGE
MESSAGE
MESSAGE
The
NUMBER OF STATUS POINTS IN GGIO1
instantiated in the GGIO1 logical node. Changes to the
the B90 is restarted.
The GGIO2 control configuration points are shown below:

PATH: SETTINGS PRODUCT SETUP

GGIO2 CF SPSCO 1(64)
 GGIO2 CF SPCSO 1

The GGIO2 control configuration settings are used to set the control model for each input. The available choices are "0"
(status only), "1" (direct control), and "2" (SBO with normal security). The GGIO2 control points are used to control the B90
virtual inputs.
GE Multilin
 
COMMUNICATIONS IEC 61850 PROTOCOL
NUMBER OF STATUS
POINTS IN GGIO1: 8
GGIO1 INDICATION
Off
GGIO1 INDICATION
Off
GGIO1 INDICATION
Off

GGIO1 INDICATION 128
Off
setting specifies the number of "Ind" (single point status indications) that are
NUMBER OF STATUS POINTS IN GGIO1
 
COMMUNICATIONS IEC 61850 PROTOCOL
GGIO2 CF SPCSO 1
CTLMODEL: 1
B90 Low Impedance Bus Differential System

GGIO1 STATUS CONFIGURATION
Range: 8 to 128 in steps of 8
Range: FlexLogic operand
1
Range: FlexLogic operand
2
Range: FlexLogic operand
3
Range: FlexLogic operand
setting will not take effect until

GGIO2 CONTROL CONFIGURATION
Range: 0, 1, or 2
5.2 PRODUCT SETUP
5
5-35