Figure 30: Ka Antenna Pointing Validation Screen - Final Validation Passed - Hughes HN9400 Installation Manual

Chapter 4
Figure 30: KA Antenna Pointing Validation screen – final validation passed
HN9400 Satellite Router Installation Guide
42
1038554-0001 Revision B
5. When pointing is complete, click Close.
6. Click Next on the Receive Antenna Pointing screen.
The KA Antenna Pointing Validation screen opens, showing a summary of the squinter
pointing results.
Note: If you open the pointing validation screen before antenna pointing is complete,
a message appears (instead of the text shown in the screen illustration above) asking
you to wait until pointing is complete. The message advises that if you exit antenna
pointing without passing final validation, the transmitter will be disabled.
Note: The Results Saved field indicates whether you saved the pointing values or
not when the DAPT prompted Store Results? near the end of the squinter pointing
process.
7. This step depends on the validation test results:
• If any validation test fails, click Back to restart DAPT antenna pointing; then re-test
until all tests pass.
• If you are using satellite-based commissioning and all four validation tests pass, click
Next to continue.
Note: The Next button shown in
screen – final validation passed
successful. If any test failed, only the Back and Exit buttons are present.
• If you are following the instructions for Ka-band manual commissioning and all four
validation tests pass, this is the last step; click Exit.
When all four validation tests have passed, Ka-band pointing is complete and validated.
Commissioning the satellite router
Figure 30: KA Antenna Pointing Validation
on page 42 is present only if final validation is