Uploading The Sbc.cfg File To The Satellite Router - Hughes HN9400 Installation Manual

Chapter 4

Uploading the sbc.cfg file to the satellite router

HN9400 Satellite Router Installation Guide
26
1038554-0001 Revision B
the power cord from the router's rear panel. Doing so could result in static electricity discharge
that could shock you and/or damage the router.
7. Make sure an Ethernet router or switch is not connected to the satellite router and to the
customer's computer.
8. Try the ping test again.
9. If the ping test is unsuccessful, call Installer Support for assistance.
The sbc.cfg file contains satellite information for SBC and the auto-commissioning server (ACS)
to be used for the commissioning process. Once you have obtained the sbc.cfg file, save it on
the installer laptop computer making sure to note the location where the file is saved.
If you do not need to upload an sbc.cfg file, go to
To upload the sbc.cfg file:
1. Open a browser on the installer laptop.
2. Type http://192.168.0.1/fs/registration/setup.html in the address bar.
3. Press Enter.
The Satellite Setup menu appears.
Commissioning the satellite router
Do not power cycle the satellite router by unplugging
Entering the antenna location on page 29.