Table of Contents
Advertisement
Commissioning the satellite router
Entering radio parameters
4. If you plan to use an antenna pointing tool, select DAPT, OPI, or N/A (for none) from the
Antenna Pointing Tool drop-down list.
For Ka-band select DAPT; for Ku-band a DAPT or OPI may be used.
5. Click Next.
Note: There is no verification screen when you manually enter the satellite parameters.
1. On the Receive LNB Selection screen, select the installed LNB from the Receive LNB
drop-down list
(Figure 22: Receive LNB Selection screen—two variations
The list of LNBs you see depends on the how the router is configured, based on its sbc.cfg
file.
Select the LNB option that matches the part number or other identifier on the installed LNB.
If you cannot find the LNB part number or identifier, refer to the LNB illustrations in
selection reference
on page 109 for guidance. If you are not sure which LNB option to select,
contact Installer Support.
LNB, the satellite router will not work.
Make sure you select the correct LNB. If you select the wrong
HN9400 Satellite Router Installation Guide
1038554-0001 Revision B
Chapter 4
on page 36).
LNB
35
Advertisement
Table of Contents
Troubleshooting
