Table of Contents
Advertisement
Commissioning the satellite router
Entering satellite parameters (manual entry)
Figure 19: Verifying the satellite parameters screen
3. Verify that the displayed information is correct and click Next.
If the parameters are not correct for the installation, click Back to change the satellite
transponder selection.
4. If you plan to use an antenna pointing tool, select DAPT, OPI, or N/A (for none) from the
Antenna Pointing Tool drop-down list.
For Ka-band select DAPT; for Ku-band a DAPT or OPI may be used.
5. Click Next.
This is an alternate method for entering the satellite parameters. You must use this method if
the satellite and transponder for your installation are not listed in the drop-down list in
18: Satellite Parameters screen
Skip this section if you selected a satellite and transponder on the Satellite Parameters screen.
The satellite parameters are provided to you in a technical update email or in an installation
specification.
To enter the parameters:
1. On the Satellite Parameters screen, select the Enter satellite parameters manually checkbox
shown in
Figure 18: Satellite Parameters screen
2. Click Next.
on page 32 and you were not provided with an sbc.cfg file.
on page 32.
HN9400 Satellite Router Installation Guide
1038554-0001 Revision B
Chapter 4
Figure
33
Advertisement
Table of Contents
Troubleshooting
