Connecting And Assembling A Dc/Dc Power Supply; Figure 7: Connecting An Ac Power Supply; Figure 8: Dc/Dc Power Supply - Hughes HN9400 Installation Manual

Chapter 3

Connecting and assembling a DC/DC power supply

HN9400 Satellite Router Installation Guide
20
1038554-0001 Revision B

Figure 7: Connecting an AC power supply

Figure 8: DC/DC power supply

HN9400 router.
Figure 8: DC/DC power supply
Connect and assemble the DC/DC power supply as follows:
1. Connect the DC power cord to the DC IN port on the router.
Note: The input cable kit is included in the power supply kit. The cable kit contains
an input power connector, connector pins, and a wiring diagram; it does not include
wire.
2. Assemble the input power cable according to the wiring diagram included in the cable kit.
on page 20 shows the DC/DC power supply used with the
Installing the satellite router