Kyocera FS-1028MFP Operation Manual page 317

TCP/IP (IPv4) Setup
Set up TCP/IP to connect to the Windows network.
Refer to TCP/IP (IPv4) Setup (by Entering IP Addresses) on page 2-12 about the procedures.
TCP/IP (IPv6) Setup
Set up TCP/IP (IPv6) to connect to the network. The default setting is Off.
Use the procedure below to setup the TCP/IP (IPv6) setting.
OPERATION GUIDE
Downloaded From ManualsPrinter.com Manuals
LAN Interface:
1 *Auto
*********************
2 10Base-Half
3 10Base-Full
Sys. Menu/Count.:a b
1 Report
2 Counter
3
********************* System
[ Exit
Login User Name:
*******************
Login Password:
[ Menu ] [ Login
6
Press the OK key. LAN Interface appears.
a b
7
Press the
interface.
The available LAN interfaces are as follows:
Auto
10Base-Half
10Base-Full
100Base-Half
100Base-Full
8
Press the OK key. Completed. is displayed and the
screen returns to the Network Setting menu.
1
In the Sys. Menu/Count. menu, press the
key to select [System], and press the OK key.
]
When you are performing user management and
L b
have not logged in, a login screen will appear.
Then, enter the user ID and password to log in, and
press [Login] (the Right Select key).
]
Default Setting (System Menu)
or key to select the desired LAN
8
or
8-129