Scsi Card Configuration (Scsiselect Utility) - Fujitsu PG-126 User Manual

3.3 SCSI Card Configuration (SCSISelect Utility)

This card contains the SCSISelect utility in this card's memory. This utility can
change this card settings without removing the SERVER cover or physically setting
the card. SCSISelect utility contains a SCSI disk utilities that can perform low-level
formatting and check the disk medium in a SCSI hard disk drive.
1) Configure/View Host Adapter Settings
I
Default settings
This card default settings are listed in the table below. If you do not need to change
these default settings, there is no need to execute SCSISelect utility.
For more information on settings, refer to the description for each setting given later
in this manual.
SCSI Bus Interface Difinitions
Host Adapter SCSI ID
SCSI Parity Checking
Host Adapter SCSI Termination
Boot Device Options
Boot SCSI ID
Boot LUN Number *
SCSI Device Configuration (#0 to #15)
Sync Transfer Rate (MB/sec)
Initiate Wide Negotiation
Enable Disconnection
Send Start Unit Command
Enable Write Back Cache
BIOS Multiple LUN Support*
Include in BIOS Scan*
*1 The setting is available only when the Multiple LUN Support is enabled.
*2 Enabled only when Host Adapter BIOS is enabled
10
1
2
2
Default setting
7
Enabled
Automatic
Default setting
0
0
Default setting
80.0
yes
yes
yes
n/c
no
yes
(To be set to "no"
except boot device)