Fujitsu PG-126 User Manual page 34

I
Connection of external SCSI device
1) Up to 15 external SCSI devices can be connected to this card.
2) Turn off the power to the external SCSI devices to be connected and remove the
3) Set up the SCSI IDs and the terminators of external SCSI devices. (Validate the
4) Connect the connector of the SCSI cable to the external SCSI 68-pin 16-bit
5) Connect the connector at the other end of the SCSI cable to the connector of the
6) To connect other external SCSI devices, connect the SCSI cable from each device
I
Connection of built-in SCSI device
1) Up to 15 built-in SCSI devices can be connected to this card.
2) Set up the SCSI IDs and the terminators of built-in SCSI devices to be connected.
3) Install the built-in SCSI device to the SERVER. For the installation instructions,
4) Connect the connector at the other end of internal SCSI cable to the Internal SCSI
5) Connect the connector of internal SCSI cable to the SCSI connector of built-in
6) Connect the power cord for the built-in device in the SERVER to the power
6
power cord from the outlet.
terminator setting of external SCSI device that is connected at the end of SCSI
cable. Then invalidate the terminator settings of other external SCSI devices.)
connector of this card.
external SCSI device.
to the previous device, and the all external devices must be connected serially.
(Validate the terminator settings of built-in SCSI device that is connected at the
end of internal SCSI cable. Then invalidate the terminator settings of other built-
in SCSI devices.)
refer to the instruction manuals of the SERVER and built-in SCSI device.
68-pin 16-bit connector of this card.
SCSI device to be connected.
connector of the built-in SCSI device.