Configuration Of Each Product - Fujitsu F2MC-8FX Setup Manual

4.1 Configuration of each product

This section describes how to configure the MCU Board and the Evaluation Board.
Configuring MCU Board
Set the following switches on the MCU Board, referring to "Figure 1 MCU Board Configuration".
LVD2 detection voltage selection jumper plug
Set the value to "LVD0".
Voltage selector switch
Set the value to "5V".
Product selector switch
Rotate the center tab to position the pointer for the corresponding number:
For 100-pin package, set the value to "0".
For 80-pin package, set the value to "1".
For 64-pin package, set the value to "2".
For 48-pin package, set the value to "3".
For none of the above, check on the settings in the MCU Board manual.
LVD selector switch
Set the value to "OFF".
Miscellaneous switches
Set "C" to "ON".
Set "CLK" to "OFF" if you use subclock, or "ON" if you don't.
Set the other switches to "OFF" (to the side of numeral letters).
Clock input selector switch
Set all to "OFF" (to the side of numeral letters)".
Subclock selector jumper plug
Set all the values to the side of "B-C".
3
GNDVCC
5V
8
PRODUCT SELECT
ON
BGM
ADAPTER
5
7
Figure 1 MCU Board Configuration
2 1
3V
ON
1 2 3 4 1 2 3 4
1
2
C B A
4
6
3