Fujitsu PG-126 User Manual page 42

14
The SCSI card standard translation scheme can be used up to a maximum
capacity of 1 GB. This card contains an extended translation scheme that
allows support of a disk drive with a capacity greater than 1 GB. Extended
translation is used only with MS-DOS 5.0 or above. When this card is used for
mirroring, this setting should be same as that of the SERVER.
When you create partitions on a disk drive with a capacity greater than 1 GB,
use the MS-DOS fdisk utility in the usual way. Since extended translation can
increase the cylinder size to 8 MB, you must set partition sizes in multiples of
8 MB. If you set a size other than a multiple of 8 MB, the fdisk utility rounds
the size up to the nearest multiple of 8 MB.
Note
Before changing the translation scheme, back up the disk drive, since
all data is lost when you change the translation scheme used.
・ Verbose/Silent Mode
This option allows you to determine whether or not to display the BIOS message
of this card at the system boot. When this option is set to 「Verbose」 , the BIOS
message of this card is displayed. The default setting is 「Verbose」 .
・ Host Adapter BIOS (Configuration Utility Reserves BIOS Space)
This option allows you to 「Enabled」 or 「Disabled」 Host Adapter BIOS. The
default setting is 「Enabled」 .
Note
・Some SCSI Select utility options are not ｢Enabled｣ unless Host
Adapter BIOS is enabled.
・Be sure set to 「Enabled」 when connecting a boot device. Otherwise,
be sure set to 「Disabled: Scan bus」 .
・ Support Removable Disks Under BIOS as Fixed Disks
Using this option allows you to control what removable-media drives this card
supports. The default setting is 「Boot Only」 . This setting has the following
options:
− Boot Only
Only a removable-media drive specified as a boot device is considered a
hard disk drive.
− All Disks
All removable-media drives that Host Adapter BIOS supports are
considered hard disk drives.