Fcc Compliance Statement - Fujitsu PG-126 User Manual

FCC Compliance Statement

This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC rules. These limits are designed to
provide reasonable protection against harmful interference in residential installations.
This equipment generates, uses, and can radiate radio frequency energy, and if not
installed and used in accordance with the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation.
If this equipment does cause interference to radio or television equipment reception,
which can be determined by turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the following measures:
・ Reorient or relocate the receiving antenna
・ Move the equipment away from the receiver
・ Plug the equipment into an outlet on a circuit different from that to which the
receiver is powered
・ If necessary, the user should consult the dealer or an experienced radio/television
technician for additional suggestions
CAUTION: Only equipment certified to comply with Class B (computer input/
output devices, terminals, printers, etc.) should be attached to this equipment, and
must have shielded interface cables.
Finally, any changes or modifications to the equipment by the user not expressly
approved by the grantee or manufacturer could void the user's authority to operate
such equipment.
Each host adapter is equipped with an FCC compliance label which shows only the
FCC Identification number. The full text of the associated label follows:
This device complies with part 15 of the FCC rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference and (2)
this device must accept any interference received, including interference that may
cause undesired operation.
E
21