Mounting Kit; Installation - CDVI SUBLIM Installation Manual

INSTALLATION MANUAL
SUBLIM
Illuminated Weatherproof Keypad with remote electronics

3] MOUNTING KIT

Varistor
Remote
-
controller
SUBLIM
1

4] INSTALLATION

Verify the distance between the SUBLIM
keypad and its remote electronic (refer to
page 3). Place the back plate of the SUBLIM
on the wall and the bracket of the remote
electronic then mark with a pen the hole
location then drill the 2 mounting holes
(6mm drill bit Ø and 35mm hole depth)
and the hole wiring access.
®
GALEO
®
GALEO
Fasten the PROFIL100EC keypad to the
back plate by using the supplied (M4x8)
Torx screw and Allen spanner hardware.
®
To fi nalize installation of the product,
insert the screw cap.
TCB TF 6
S6
wood lobe
plastic
screws screw
anchor
(4.5x35) (M4x8)
- - -
3 3 1
Insert the 3 plastic anchors in the holes.
Mount the back plate of the SUBLIM
with the (M4x35) mounting screws.
5
Insert the 2 plastic anchors in the
holes. Place the bracket of the electronic
and screw on the wall using the supplied
M4x30 screws. Slide the box from up
to down on the bracket.
Countersunk
T20 Screw-
Phillips
screw- driver
screw
driver case
(M4x35)
- - 2
1 1 2
Fixing plate
Wire
Plastic
sealing
anchor
cap
controller
2 2
2 -
3
Insert the cable in the hole access area
of the back plate.Then mount the keypad
on the back plate, placing fi rst the top
in the hooks and then the bottom.
(x2)
(x2)
Insert the cable in the remote electronic
and wire the cable to the terminals.
Don't forget to install the varistor on the lock
(refer to page 4, Notes and Recommen-
dations).
cdvi.com
cdvigroup.com
EN
for the
remote
1
-
13