Page 1
IN CODES AND EMOTE LECTRONICS The GALEO keypad is available in 1, 2 or 3 relay output. Refer to page 5 for for the instruction of version 2 and 3 relay of the GALEO. EYPAD EMOTE LECTRONIC Packing Checklist :...
EQUEST XIT INPUT This normally open loop that operates upon activation relay 1 (GALEO, GALEO 2 or GALEO 3) or relay 2 (GALEO 2 or 3 version). This feature is especially useful when controlling a lock. P1 input activates relay 1.
Version 01/2005 G0301FR0234V01 II. PROGRAMMING A. T IME OUTPUTS This section allows to program the backlighting time and the Relay activation time 1. Enter the master code twice (12345 default value master code). 2 beeps are emitted to confirm entry in programming mode. 2.
Version 01/2005 G0301FR0234V01 Put the power back. Wait approximately 3 seconds. Two beeps are emitted to confirm reset of the keypad. Remove P2 jumper. The master code is restored to its default value 12345 and all the User codes are deleted from the keypad. E.
ROGRAMMING NSTRUCTION Programming instructions are the same as for the GALEO keypad with 1 relay output. GALEO 2: 2 relay outputs N/O and N/C contacts 8A @ 250V~ Group 1: from user location 00 to user location 59 to activate relay 1...
Page 6
Version 01/2005 G0301FR0234V01 Wiring diagram between the GALEO and the Remote Controller P2: Place jumper for reset P3: Individual Code modification by user ST1: Cut the wire to disable the audible signal 12 V R1 C1 T1 R2 C2 T2 R3 C3 T3 P1 M P2 Px H H...