Irig-B Distribution Adapter - GE Multilin D400 Instruction Manual

IRIG-B distribution adapter

64
LED transmitters are classified as IEC 60825-1 Accessible Emission Limit (AEL) Class
1M. Class 1M devices are considered eye safe to the unaided eye. Do not view directly
with optical instruments.
Figure 36: IRIG-B Input Adapter
The IRIG-B Distribution Adapter (GE Item No. 520-0212LF) is an optional IRIG-B output card
to supply a pulse width coded IRIG-B (TTL) signal passed from the IRIG-B Input card to
attached IEDs. The IRIG-B Distribution card provides four channels on a single terminal
block. Each channel is capable of supplying a signal to up to four IEDs, for a total of 16
IEDs. The IRIG-B Distribution card plugs into a dedicated IRIG-B slot (slot 10) on the D400.
Terminal blocks accept a range of 24 to 14 AWG [0.2 to 2.1 mm²] Recommended wire strip
length is 0.2" [5.0 mm]. Screws shall be torqued with tool setting of 4.2 in-lb [0.46 Nm]. A 3.0
to 3.5 mm flat screwdriver tip is recommended.
Figure 37: IRIG-B Distribution Adapter
Table 16: IRIG-B Distribution Terminal Block Signal Definitions
Channel Terminal Block Position
Channel 1 1
2
3
Channel 2 4
5
Channel 3 6
7
8
Channel 4 9
10
The terminal block positions are numbered from 1 to 10 starting from the bottom of the
card.
GE INFORMATION
CHAPTER 4: CONNECTING TO DEVICES AND NETWORKS
Function
IRIG-B TTL
GND
FGND
IRIG-B TTL
GND
IRIG-B TTL
GND
FGND
IRIG-B TTL
GND
D400 SUBSTATION GATEWAY INSTRUCTION MANUAL
Signal Flow
OUT
-
-
OUT
-
OUT
-
-
OUT
-