Alarms - Weinmann VENTIlogic LS Instructions For Use Manual

Fault/fault message
Nail varnish, dirty fingers
SpO signal weak
2
Patient shock

8.2 Alarms

A distinction is made between two kinds of alarm.
• Physiological alarms are those alarms which affect the patient's ventilation
directly.
• Technical alarms are those alarms which affect the configuration of the device.
The alarms are classified into three priorities:
• low-priority alarms, indicated by the symbol
continuously illuminated yellow LED and an acoustic alarm issued (buzzer)
• medium-priority alarms, indicated by the symbol
a flashing yellow LED and an acoustic alarm issued (buzzer)
• high-priority alarms, indicated by the symbol
a flashing red LED and an acoustic alarm issued (buzzer)
8.2.1 Deactivate alarms
The doctor supervising treatment can decide which physiological alarms to activate or
deactivate. If the symbol
been deactivated by the supervising doctor (see "Physiological alarms" on page 84).
8.2.2 Acknowledging alarms
Cause of fault
Check SpO
need be
Check patient condition
appears in the status line, all the physiological alarms have
If a fault triggers an alarm (in this case: disconnection
alarm), you can have the acoustic alarm paused for about
120 seconds by pressing the alarm acknowledgement
key .
Remedy
sensor and fingertip and clean if
2
in the alarm window, a
in the alarm window,
in the alarm window,
Troubleshooting EN 83