In gas- and glow-powered aircraft where vibration is present, the servos should be mounted using the supplied
rubber grommets and bushings. Do not over-tighten the mounting screws. The diagram will assist you in properly
mounting the grommets and bushings. In electric and non-powered aircraft, there are many acceptable methods
for mounting the servo, including servo tape and even glue. See the information included with your aircraft for the
recommendation for installing servo(s) in your aircraft.
Servo Mounting Flange
Rubber Grommets
Servo Arm Retaining Screw
Servo Mounting Flange
Servo Arm/Horn
Servo Output Shaft
Rubber Grommets
Servo Case
Servo Eyelet
Servo Lead w/Connector
16