Specifications; Receiver Connection And Installation - Spektrum SR310 Instruction Manual

SR310 Instruction Manual
The Spektrum™ SR310 4-channel DSMR® Sport Surface receiver is compat-
ible with all Spektrum DSMR surface transmitters. The SR310 receiver is NOT
compatible with DSM® or DSM2® transmitters.

Specifications

Type: DSMR
Dimensions (LxWxH):
Channels: 4
Band: 2.4GHz
Bind/Battery Port

Receiver Connection and Installation

Install the Receiver in your vehicle using double-sided foam servo tape. Foam
servo tape will hold the receiver in place and help isolate it from vibrations.
Mount the antenna up and away from the vehicle in an antenna tube. The
higher up the antenna is, the better signal it will receive. The last 31mm of
the antenna is the portion that receives the signal from the transmitter.
NOTICE: Do not cut or modify the antenna.
Failsafe
The throttle failsafe position is set during binding. In the unlikely event that
the radio link is lost during use, the receiver will drive the the throttle servo
to its pre-programmed failsafe position (normally full brakes) and all other
channels will have no servo output. If the receiver is turned on prior to turning
on the transmitter, the receiver will enter the failsafe mode, driving the the
throttle servo to its preset failsafe position. When the transmitter is turned on,
normal control is resumed.
IMPORTANT:
Failsafe activates only in the event that signal is lost from the
transmitter. Failsafe will NOT activate in the event that receiver battery power
decreases below the recommended minimums or power to the receiver is lost.
1.30 x .80 x .53 in (32.8 x 20.3 x 13.5mm)
Weight:
0.25 oz (7.2 g)
Voltage Range: 3.2–9.6V
Bind Plug
LED
Antenna
Aux 2 Port
Aux 1 Port
Throttle Port
Steering Port
EN