Installation - Spektrum PowerSafe AR9100 User Manual

Installation

• Mount the main PowerSafe unit in the position that you would normally
mount the receiver.
• Mount the switch on the side of your aircraft and insert the switch plug
into the port in the main unit marked SWITCH.
Note: The PowerSafe uses a specifically designed switch.
Conventionally wired switches are not compatible with the PowerSafe.
• Using the above guidelines select the battery system that best fits your
application and install the batteries in your aircraft. Connect the battery
to the PowerSafe. Spektrum batteries are pre-wired with an E-flite EC3
connector and plug directly in. If using another brand of battery, it will
be necessary to solder EC3 connectors to the included battery leads.
• Using double sided foam tape and tie wraps, mount a minimum of 2 and
up to 4 remote receivers in your aircraft and plug them into the receiver
ports.
9
Note: It's important that one receiver be plugged into port A and a second
receiver be plugged into any other port in order to operate.
• Plug the servo leads into the appropriate ports in the PowerSafe
• You are now ready to bind the system
• Turn on the system. A blue light on the main unit and an amber light on
the remote receiver should turn on indicating the system is powered.
Check servo operation.
Spektrum AR9100