General Notes About Assembly; Bottom Bracket; Headset; Speed Sensor - Specialized VADO User Manual

4. GENERAL NOTES ABOUT ASSEMBLY

This user manual is not intended as a comprehensive use, service, repair or maintenance guide. Please see your
Authorized Specialized Retailer for all service, repairs or maintenance. Your Authorized Specialized Retailer may
also be able to refer you to classes, clinics or books on bicycle use, service, repair, and maintenance.
WARNING! Due to the complexity of the VADO bicycle, proper assembly requires a high degree of
mechanical expertise, skill, training and specialty tools. Therefore, it is essential for your safety that
the assembly, maintenance and troubleshooting be performed by an Authorized Specialized Retailer.
WARNING! Do not sand, drill, file or remove parts from your bicycle. Do not install incompatible
components or hardware. Failure to follow this warning may result in serious personal injury or death.
WARNING! Electrical components can be exposed when working on your bicycle. Do not touch
any part of the electrical system while under electric charge. Do not expose the connections of
the battery and frame to water. If any live components or the battery are damaged, stop riding
immediately and bring your bicycle to your Authorized Specialized Retailer.
Your VADO frame does not require any bottom bracket or head tube pre-installation preparation. All surfaces are
already prepared from the factory.
The VADO frames use a 1 1/8" (41.8mm x 8mm x 45°) Campagnolo Standard compatible top and bottom bearing.
Ensure that replacement bearings are compatible with the Specialized headset specification. No tools are needed
for installation or removal of both bearings. Grease bearing surfaces before installation.
When assembling the rear brake disc, the Speed Sensor Magnet must be installed on the rotor (fig.2). Four of the
six bolts are standard rotor bolts. The remaining two bolts (M5 x 0.8 pitch x 15mm length, with countersunk flat
head) attach the Speed Sensor Magnet to the rotor.
2
DISC BRAKE ROTOR
STANDARD
ROTOR
BOLTS
FLAT HEAD
M5 x 15mm
SPEED SENSOR MAGNET

4.1. BOTTOM BRACKET

4.2. HEADSET

4.3. SPEED SENSOR

4