Deleting The Remote Path - Hitachi AMS 2000 User Manual

iSCSI example:
% aurmtpath –unit array-name –refer
Initiator Information
Local Information
Array ID
Distributed Mode : N/A
Path Information
Interface Type
Remote Array ID
Remote Path Name
Bandwidth [0.1 M] : 100
iSCSI CHAP Secret
Path
0
1
Target Information
Local Array ID
%

Deleting the remote path

When the remote path becomes unnecessary, delete the remote path.
Prerequisites
The pair status of the volumes using the remote path to be deleted must be
Simplex or Split.
Do not perform a pair operation for a TCE pair when the remote path for
theTCE pair is not set up. A pair operation may not complete correctly.
NOTE: When performing the planned shutdown of the remote array, the
remote path should not necessarily be deleted. Change all the TrueCopy
pairs in the array to the Split status, and then perform the planned
shutdown of the remote array. After restarting the array, perform the pair
resynchronization. However, when the Warning notice to the Failure
Monitoring Department at the time of the remote path blockade or the
notice by the SNMP Agent Support Function or the E-mail Alert Function is
not desired, delete the remote path, and then turn off the power of the
remote array.
To delete the remote path
1. From the command prompt, register the array in which you want to
delete the remote path, and then connect to the array.
2. Execute the aurmtpath command to delete the remote path. For
example:
•
Hitachi AMS 2000 Family TrueCopy Extended Distance User Guide
: 85000026
: iSCSI
: 85000027
: N/A
: Disable
Status Local
Normal 0B
Normal 1B
: 85000027
Operations using CLI
Remote Port
Remote IP Address
N/A 192.168.0.201
N/A 192.168.0.209
TCP Port No. of
Remote Port
3260
3260
A–17