Hitachi AMS 2000 User Manual page 101

down again. Check that the spin-down instruction has not been issued
or has been completed (no RAID group in the Power Saving Status of
Normal(Command Monitoring) exists) before restarting the array.
To install the option, restart the array. The feature will close upon
restarting the array. The array cannot access the host until the reboot is
completed and the system restarts. Make sure that the host has stopped
accessing data before beginning the restart process.
NOTE:
• To install the option, restart the array. The feature will close upon
restarting the array. The array cannot access the host until the reboot
is completed and the system restarts. Make sure that the host has
stopped accessing data before beginning the restart process.
• After unlocking the operated option, even when the array does not
reboot, the status of the option displays as enabled, but TCE cannot be
operated until the array reboots. To use the option, reboot the array.
• Restart usually takes from 6 to 25 minutes.
• It may take time for the array to respond, depending upon the
condition of the array. If it does not respond after 25 minutes or more,
check the condition of the array.
10.A message appears stating that the restart is successful. Click Close.
Installation of TCE is now complete.
Hitachi AMS 2000 Family TrueCopy Extended Distance User Guide
Installation and setup
6–5