Hitachi AMS 2000 User Manual page 189

•
Figure B-1: Horcm0.conf Example
6. Save the configuration definition file and use the horcmstart command
to start CCI.
7. Execute the raidscan command; in the result, note the target ID.
8. Shut down CCI and open the configuration definition file again.
9. In the HORCM_DEV section, set the necessary parameters. For the
target ID, enter the ID of the raidscan result. For MU#, do not set a
parameter.
10.In the HORCM_INST section, set the necessary parameters, and then
save (overwrite) the file.
11.Repeat Steps 3 to
example of the horcm1.conf file.
•
Figure B-2: Horcm1.conf Example
Hitachi AMS 2000 Family TrueCopy Extended Distance User Guide
10 for the horcm1.conf file.
Operations using CCI
Figure B-2 shows an
B–5