Danfoss AK-SM 350 Manual page 26

The following settings only apply if "Analogue input" was selected in
point 3.
Analogue input - AI
This list of settings was
previously covered under
temperature. Please see the
explanation on pages 24-25.
Signal type
This is where you set whether it is a voltage signal or a current
signal.
unit
This is where you set the name of the signal.
26 Manual RS8EF402 © Danfoss 02-2009
Readout at max. signal
This is where you set the value that will be presented when the
input signal is at its highest (max. 10 V or 20 mA).
Readout at min. signal
This is where you set the value that will be presented when the
input signal is at its lowest (min. 0 V or 4 mA).
AK-SM 350 Version 1.7x