Danfoss AK-SM 350 Manual page 21

Device name
The factory enters the type designation in this position. The name
can be changed as required. Use the four arrow keys to change
the text.
Daylight saving
This is where you set whether the monitoring unit's clock function
is to switch to summer/winter time at the appropriate date and
time.
If a change to summer/winter time is required, you must select the
relevant European or US times.
The monitoring unit will change time itself when the day arrives to
put the clocks forward/back.
Time zone
0 is UK (GMT) time.
1 represents the time zone Germany, France, Spain, Italy, etc.
Date and time
This is where you set the date and time.
A battery in the monitoring unit will maintain the clock function
in the event of a power failure. The battery will normally last for
several years and an alarm will be generated when the battery is
due to be replaced.
Names of measuring units
This is where you set which units the various readings will be
shown in:
SI: Bar and Kelvin K, (°C)
US: Psi and °F
Danfoss SI: Bar and °C (pt is no different to the SI setting).
AK-SM 350 Version 1.7x Manual RS8EF402 © Danfoss 02-2009
Service password
A password can be entered if you need to limit access to the
important settings. Once access has been achieved with this pass-
word, it will be possible to carry out service and install new setups.
Password for daily access
A password can be entered if you need to limit access to the daily
settings. Once access has been achieved with this password, it will
be possible to make settings.
Access without using a password
If a password is used for daily use and/or for service, access with-
out the use of codes will be limited to read-only parameters.
Timeout of network
If the monitoring unit cannot contact a controller on the network,
it will try again. This will happen repeatedly, and if it does not suc-
ceed in contacting the controller within the set time, an alarm will
be generated.
Delete a controller from the network
This function must be used if a controller is deleted from the data
communication. The function updates the network list so that "of-
fline controllers" are deleted from the network list.
21