Electrically Adjustable Leg Supports Separate; Setting The Length Of The Leg Supports; Setting The Height Of The Calf Supports - Degonda-Rehab SA TwistT4 Operating Instructions Manual

Electrically Adjustable Leg Supports Separate

Setting the Length of the Leg Supports

Requirements:
 Allen key, size 3
 Spanner, 8mm
 Loosen the screw with the Allen key (1),
on the opposite side hold against rotation with the
spanner. Remove the screw and nut.

Set the telescopic tube to the desired
length. Do not go beyond the red mark.
 Refit the screw and nut and tighten with the Allen
key (1).
ATTENTION!
The screw must be tightened through the holes of the leg support and the telescopic
tube. The telescopic tube must not be pulled out further than up to the red mark on
the leg support.

Setting the Height of the Calf Supports

Requirements:
 Spanner, 10mm
 Loosen (1) with the Allen key
 Set the desired height
 Tighten (1) with the Allen key
- 29 -
1
1
1