Setting The Width Of The Side Sections (Bioseat); Setting The Backrest Standard Seat With Gas Spring - Degonda-Rehab SA TwistT4 Operating Instructions Manual

Setting the Width of the Side Sections (Bioseat)

Requirements:
 Allen key, size 5
 Loosen the screw with the Allen key (1)
 The complete armrest can now be set to the
desired width (2).
 Retighten the screw with the Allen key (1).
ATTENTION! The side sections must not be pulled out further than the red mark.
Setting the Backrest

Setting the Backrest Standard Seat with Gas Spring

The backrest of the standard seat is set by a lever which can be found on the back next
to the gas pressure spring. The backrest setting is infinitely variable.
 Lift the lever (1).
 At the same time pull the backrest backwards
until the desired backrest angle is set.
 Release the lever (1)
- 27 -
2
1
2
1