The R-Net Control Panel
Design of the Control Panel R-NET LED
Control elements:
1)
On / off button
2)
Hazard lights
3)
Horn
4)
Lights
5)
Setting mode activation
6)
Indicator left
7)
Driving profile speed reduction
8)
Driving profile speed increase
9)
Indicator right
10) Joystick
On / Off Button
Switch on the control panel (ON / OFF button). The LED's on the
control panel light up. The wheelchair is ready to drive.
Battery Charge Indicator
All diodes light up (red, yellow, green): Full range.
Diodes light up (red, yellow): Very low range
Diodes light up (red): Charge the battery immediately!
INFORMATION
Protection against complete draining: After a certain driving time on battery reserve the
electronics of the drive switch off automatically and the wheelchair remains stationary.
Activating the Electrical Setting Mode
Press the button "MODE" (1)
The control panel changes to the last used
setting mode.
By operating the joystick to the right
the display changes (2-3-4) (lights up)
to the desired setting mode.
By pressing the "MODE" button again the drive mode is returned to
3
1
2
6
7
4
- 16 -
4
5
8
9
2
1
3