Setting The Foot And Leg Supports; Standard Leg Supports Separate; Setting The Length Of The Leg Supports - Degonda-Rehab SA TwistT4 Operating Instructions Manual

Setting the Foot and Leg Supports

Standard Leg Supports Separate

Setting the Length of the Leg Supports

Requirements:
 Allen key, size 3
 Spanner, 8mm
 Loosen the screw with the Allen key
(1), on the opposite side hold against
rotation with the spanner. Remove the
screw and nut.
 Set the telescopic tube to the
desired length.
Do not go beyond the red mark.
 Refit the screw and nut and tighten with the
Allen key (1).
ATTENTION!
The screw must be tightened through the holes of the leg support and the telescopic
tube. The telescopic tube must not be pulled out further than up to the red mark on
the leg support.
- 28 -
1