Reset To Factory Defaults - Fluke 434-II User Manual

Reset to Factory Defaults

Proceed as follows to reset the Analyzer to factory default settings (initial setups, limits,
etc.):
Turn power off, then press and hold SAVE SCREEN and turn on again. You should hear
a double beep,
OR
Use submenu SETUP, USER PREF. as a starting point. How to get there is explained
above under Menu Navigation:
info@Fluke-Direct.ca
Press to start the reset to default settings. Because of the risk
F1
of unwanted erasure of data, a confirm menu pops up.
Press to confirm the reset.
F5
Fluke-Direct
Basic Operations and Menu Navigation
Reset to Factory Defaults
.ca
1.800.868.7495
4
4-7