Fluke 434-II User Manual page 166

Fluke 434-II/435-II/437-II
Users Manual
Installing the USB Drivers
To install the USB drivers, do the following:
1
2
B-2
info@Fluke-Direct.ca
Connect the Fluke 430 Series II
instrument to the PC, using the USB-
cable supplied with the instrument. The
cable may be plugged in and out even
when both the computer and the
instrument are switched on ('hot-swap'),
it is not required to power either one
down.
When the appropriate drivers for the
Fluke 430 series II instrument have not
yet been installed, Windows will show
that New Hardware is detected and the
Wizard for the installation of new
drivers will open.
Depending on your PC settings and
operating system, Windows may ask for
permission to search the Windows
Update Web site on the internet for the
latest revision. If you have internet
access at such moment, it is
recommended to select "Yes", then
"Next", so as to get the latest revision of
the drivers.
In case no internet access is available,
install the drivers from the CD-ROM or
from a location on the hard drive. For
that, select "No, not this time".
In the following window, click "Next"
to install the software automatically. In
case drivers should be loaded from CD-
ROM, select 'select from a list or
specific location' instead.
Fluke-Direct
.ca
1.800.868.7495