Mira Mode Instructions Manual page 27

Back Face Installation
Note! This installation is only possible
with a finished wall thickness of between
4 and 21 mm, and is normally associated
with the installation into laminated panels
or preformed shower cubicles.
1. Decide on a suitable position for mixer
where all users can operate.
2. Determine the route for the incoming hot
and cold supply pipework.
3. Determine the route for the outlet
pipework.
4. Cut a 110 mm diameter hole in the panel
and mark the fixing holes for the support
bracket at 45°.
5. Drill and countersink the fixing holes to
accept the M4 x 30 mm screws (supplied).
6. Install the hot and cold supply pipes.
7. Fix the support bracket and shower
control in position using the two M4 x 30
mm screws (supplied).
Note! The support bracket requires a
clearance depth of 70 mm, with a finished
wall thickness of between 4 and 21 mm.
110 mm
Diameter
M4 x 30 mm Screws
27
Support
Bracket
Front Face
110 mm
Diameter