Mira Mode Instructions Manual page 20

Shower Fittings
1. Temporarily fit the shower arm and the
support bracket to the outlet of the
shower control and mark the hole
position. Ensure the support bracket
is fitted no more than 90mm below the
top of the shower arm
Note! Use a spirit level or other device
to ensure shower arm is vertical.
2. Remove the shower arm and support
bracket.
3. Drill the wall and insert a suitable wall
plug (supplied). Fit the wall plate to the
wall.
4. Refit the shower arm and support
bracket. Attach to the support
bracket to the wall plate.
5. Ensure supply pipework is flushed
through before fitting shower rose.
6. Attach the shower rose to the
shower arm and tighten.
Shower Arm
20
90 mm Maximum
Wall Plate
Support Bracket
2.5 mm A/F
Hexagon Wrench
Shower Arm
Shower Rose