Mira Mode Instructions Manual page 16

Regulators
Two grey flow regulators are supplied with the product. They fit into the cold and/or
hot inlet connectors for high pressure systems.
The selection table indicates when and where these can be fitted.
Fitting Regulator
1. Remove compression nut and
olive from inlet elbow or
connector.
2. Ensure 'o' seal is fitted to flow
regulator and push inside until
flange locates up against
internal shoulder of inlet elbow/
connector.
3. Make compression fitting using
compression nut and olive.
Optional
'O' Seal
Flow Regulator
16
Inlet Elbow/Connector
Incorrect Fitting
Olive
Compression Nut
Inlet Tube